(Or, right-click on the PLC in the project tree and select Work Online). I/O Memory address of AIO (analog I/O) is determined with the rotary switchs (Unit No.) on theĬreate an I/O Table online following the steps below. I/O Memory address of DIO (contact I/O) is automatically determined by I/O table creation according to the mounted location of the Basic I/O Unit. I/O Memory address of DIO (contact I/O) and AIO (analog I/O) The I/O tables are transferred to the CPU Unit.
#Cx programmer set connection type Offline#
I/O tables can be created by the following two procedures:Ī) Create I/O table: Creating I/O tables based on mounted Unitsī) Configure I/O table: I/O tables creation offline without mounted Units on the Pesonal Computer. The information of mounted unit type and locations of all Units is called "Resistered I/O tables".ĬPU Unit recognizes the mounted Units according to this information. Going Online with the PLC and Creating I/O TablesĪllocate I/O Memory based on the actual I/O (Basic I/O Unit) and CPU Bus Unit. OFF: Use RS-232C port parameters set in the PLCĨ. SW5: ON: Auto-detect CX-Programmer parameters at OFF: Auto-detect CX-Programming console or CXProgrammer parameters at the periferal port. SW4: ON : Use peropheral port parameters set in the When connecting to RS232C port through "SYSMAC WAY": SW5=OFF When connecting to Peripheral port through Toolbus: SW4=OFF
#Cx programmer set connection type serial#
Set the parameters for Serial port (Peripheral or RS232C port) communication and automatic program transfer enabled/disabled when power is turned ON.Įxample: When PLC Settings is in default setting.
Set the initial hardware configuration for the CPU Unit. Refer to Appendix3-2 Connections via Ethernet to directly connect the CX-Programmer toĦ. (CPU Peripheral port or RS232CĬonnection to Peripheral port: CS1W-CN226/626Ĭonnection to RS-232C port: XW2Z-200S-CV/500S-CV Connecting the Personal Computer and CPU Unit with Serial Cable.Ĭonnect CX-Programmer to the CPU Unit with a serial cable. Note: The network settings must be identical to the settings in the CPU Unit.(DIP sw and PLC Settings).ĥ. Connect the personal computer to the CPU Peripheal (1)For serial comunciation, select Toolbus. Set the network type to communicate with PLC. (4)Set the CPU Type (CPU** in the table above) and click the OK button. (2)Select Device Type in the pull-down list to specify the PLC type. (1)Change PLC dialogue box will be displayed on the display
0 kommentar(er)
